| № |
Part number |
Description |
|
|
|
AIR BAGS |
|
|
|
|
REFER TO PROCEDURE EXPLANATION 29 FOR SUPPLEMENTAL RESTRAINT/AIR BAG SPECIAL CAUTIONS. |
|
|
|
|
SUSPENSION |
|
|
|
|
MANUFACTURER ADVISES THAT SOME NEW FASTENERS MUST BE USED WHENEVER OLD FASTENERS ARE LOOSENED OR REMOVED. |
|
|
|
|
MANUFACTURER RECOMMENDATION |
|
|
|
|
THE VEHICLE MANUFACTURER ADVISES THAT DUE TO THE USAGE OF VERY HIGH STRENGTH STEEL ON THE INNER COMPONENTS AND REINFORCEMENTS SECTIONING OF THESE PARTS ARE NOT ALLOWED, COMPLETE REPLACEMENT OF THE COMPONENT OR REINFORCEMENT IS THE ONLY ACCEPTABLE REPAIR. IT WILL BE NECESSARY TO USE A TUNGSTEN CARBIDE DRILL BIT TO RELEASE THE SPOT WELDS ALONG THE AREAS WHERE PARTS JOIN OTHER COMPONENTS. |
|
|
|
|
MANUFACTURER RECOMMENDS THAT DUE TO DESIGN OF THE REAR FLOOR PAN, SECTIONING IS NOT PERMITTED. |
|
|
|
|
MANUFACTURER DOES NOT APPROVE OR ENDORSE THE USE OF STRUCTURAL ADHESIVES ALONE IN THE REPLACEMENT OF BODY PANELS. |
|
|
|
|
WELDING |
|
|
|
|
MANUFACTURER RECOMMENDS THAT WELDED PANELS BE REPLACED USING THE WELD BONDING METHOD. SEE MANUFACTURER COLLISION BULLETIN 31-007-12 FOR REPAIR GUIDELINES. |
|
|
