| № |
Part number |
Description |
|
|
|
AUTHORIZED REPAIR FACILITY |
|
|
|
|
MANUFACTURER RECOMMENDS THAT BODY STRUCTURE REPAIRS BE DONE BY AN AUTHORIZED REPAIR FACILITY. |
|
|
|
|
AIR BAG |
|
|
|
|
REFER TO PROCEDURE EXPLANATION 29 FOR SUPPLEMENTAL RESTRAINT/AIR BAG SPECIAL CAUTIONS. |
|
|
|
|
ALUMINUM |
|
|
|
|
MANUFACTURER ADVISES THAT SOME NEW FASTENERS MUST BE USED WHENEVER OLD FASTENERS ARE LOOSENED OR REMOVED. |
|
|
|
|
CORROSION PROTECTION |
|
|
|
|
WITH THE EXTENSIVE USE OF ALUMINUM CONSTRUCTION, CORROSION CAUSED BY CONTACT BETWEEN DISSIMILAR METALS MAY RESULT IF THE WRONG FASTENING COMPONENTS (SCREWS, BOLTS, NUTS, WASHERS, RIVETS, PLUGS, GROMMETS, ADHESIVES, ETC.) ARE INSTALLED. |
|
|
|
|
MANUFACTURER RECOMMENDATION |
|
|
|
|
LABOR TIMES FOR WELDED, WELD BONDED OR RIVET-BONDED PANELS DO NOT INCLUDE FRAME SET-UP ON STRAIGHTENING BENCH AS PER MANUFACTURER RECOMMENDED PROCEDURES. |
|
|
|
|
SUSPENSION |
|
|
|
|
OBSERVE MANUFACTURER REQUIREMENTS FOR SELF-LOCKING FASTENERS |
|
|
|
|
CRUISE CONTROL SYSTEM |
|
|
|
|
MANUFACTURER ADVISES THAT CALIBRATION OF THE ADAPTIVE CRUISE CONTROL SYSTEM MUST BE DONE WHENEVER A FOUR WHEEL ALIGNMENT IS PERFORMED. |
|
|
|
|
WELDING |
|
|
|
|
BEFORE INITIATING ANY REPAIR INVOLVING THE USE OF AN ELECTRIC WELDER, THE IGNITION MUST BE IN THE OFF POSITION AND BATTERY DISCONNECTED. |
|
|
